Converter from Shape format

Procedure is intended for batch loading of the vector data from exchange format Shapefle.

The dialog box contains two pages (tabs): Common and Options .

Batch operation is based on primary customizing the parameters of conformity and their subsequent use.

At loading the same-type data (from one source) or periodic loading of the same data (periodically updated) it is enough to generate once the project of processing and subsequently to use it.

Thus, the page Options is intended only for primary customizing the project.

At stream processing it is enough to specify parameters on page Common.

Necessity of entering the amendments (at change of input data) on page "Options" can also be traced on page Common in the field of the information and statistics.

In general, process of loading the data (at presence of the preliminary project) might look like this:

1. Activation of procedure, a primary choice of a set of loaded data.

2. Specification (if necessary) the list of loaded data.  

3. Choice of an output map.  

4. Choice of a mode of creating an output map: "New, "Renew, "Add, "Change".

5. Choice of the classifier (if necessary, if the output map is a new one, does not exist yet).

6. Choice of configuration file (project).

7. Specification of the initial mathematical basis.

8. Inclusion (if necessary) of the mechanism of final sorting the data.

9. Execution of procedure.

In case of absence of the customized project it is necessary to execute preliminary configuring the conformity of codes and semantics. The customized conformity can be saved in the form of a file of the project's settings (.SHI).

In case of loading the set obtained by unloading a map by means of software products "Panorama", the customizing the project is not required. All settings are done automatically. After you have chosen the output map and the classifier, it is possible to make active an execution of process.